Tutorial CCS Wands and Keys

Card Captor Sakura © CLAMP

　Fonts Used;
SimSun
Nauert
Trebuchet MS
Arial

　Other Photo's;
CCS Prop WIP 001
CCS Prop WIP 002
CCS Prop WIP 003
CCS Sakura's Magic Keys
CCS Clow Wand
CCS Star Wand

ALSO: You might find these 3D Star Templates useful.

I got a piece of card, and sorta 'rolled' it around the Pepsi lid. The rubber bands in the photo's were to keep it in place as the glue dried, and I used a few layers of very thin card (it's flexible so it's easier to make cylinders with it) so that it was really strong.

Something else you could use for the cylinder - the card tube you get on the inside of wrapping paper, just cut maybe 5cm or so. Cut a circle from a piece of card that's the same size as the hole of the tube, super-glue the bottle-lid to it, then tape this to the cylinder. Simpler and easier than what I did!

The reason why I made this is because I wanted to seperate the 'head' of the wand so I didn't have to make two seperate sticks for each wand.

The cylinder was to hide the lid and to make it look neater. It also gives a little extra support, because Pepsi lids are quite small and without the long cylinder, the clow/star head of the wand could just break off.